Important application points include primary loop of nuclear power plants, boiler bleed-water in thermal power plants, denitrification of drinking water, and catalytic reduction of oxygen on noble metal surfaces in water treatment plants. The dissolved hydrogen concentrations within the water/ steam loop of a power plant gives quantitative and qualitative evidence of the rate of corrosion, corresponding to the buildup or destruction of the protective oxide layer inside pipes and boiler tubes.
Portable system – Model 9091C available
Fully automatic remote calibration
Wide range analysis: 0-1000 μg/L, 0-10 mg/L, 0-100 cc/kg
Automatic temperature and flow compensation
Fast response time (t90 = 30 sec)
No zero point adjustment required
Withstands pressures up to 8 bar (116 psi)
Analog and digital outputs
Minimal maintenance required
Automatic operation
Range
0 - 1000μg/L, 0-10 mg/L
Accuracy
+/- 3 % of reading
Response Time
t90 = 30 sec
Temperature Compensation
Automatic
Calibration
Automatic or manual
Current Outputs
0-20mA, 4-20mA (shunt max 500 Ohm)
Digital Outputs
serial interface RS232
Alarms
flow, calibration, power
Power
100VAC - 240 VAC, 50/60 Hz
Sample Flow
3 - 18 L/h
Sample Temperature
32-140° F (0-60° C)
Ambient Temperature
32-131° F (0-55° C)
Pressure
0.3 - 8 bar (5 - 116 psig)
Recommended Conditioning
Sample should be filtered to 60 microns
Sample Conductivity
≥ 2μS/cm ; salt cell is required if conductivity is less
Dimensions
Transmitter: Height=5.5” (14 cm), Width=7” (18 cm), Depth=7” (18 cm)
Wet Section: Height=6” (15 cm), Width=4” (10cm), Depth=6” (15 cm)
Europe Sales & Service:
China Sales & Service:
Email: